Low-Sugar Jam

How to can raspberry jam without pectin?

You can water-bath can raspberry jam without pectin only with a tested recipe. Learn the gel point, the canning steps, and why you should not change the amounts.

On this page
  1. Short answer
  2. Why pectin-free jam is harder to get right
  3. The gel point and the plate test
  4. Water-bath canning steps
  5. Why you should not change a tested recipe
  6. If you do not want to can
  7. Storage and safety

Short answer

You can can raspberry jam without added pectin, but only with a tested recipe. Without pectin, the jam sets by cooking the fruit and sugar down to a gel. Home recipes vary a lot in sugar, fruit, and processing time, so start with a tested source such as the National Center for Home Food Preservation (NCHFP), which publishes USDA-based guidance.

Why pectin-free jam is harder to get right

Raspberries have some natural pectin, but usually not enough to set a jam on their own. The cook has to rely on long simmering, enough acid, and enough sugar. If any of those are off, the jam may stay runny, or it may set too firmly. Both problems make it harder to judge whether the jar is safe to store on the shelf.

The gel point and the plate test

The jam is ready when it reaches its gel point. At sea level, that is about 220°F (104°C). Water boils at a lower temperature at higher altitude, so the target goes down there. Check the altitude guidance in your tested source before you cook.

If you do not use a thermometer, use the chilled-plate test:

  1. Put a small plate in the freezer before you start.
  2. Spoon a little of the hot jam onto the cold plate.
  3. Wait about a minute, then push the jam with your finger.
  4. If it wrinkles and holds a track, it has reached the set.

Take the pan off the heat while you test, so the jam does not keep cooking.

Water-bath canning steps

These steps are general. Use the processing time from your tested recipe.

  1. Wash and heat the jars and lids as the tested recipe describes.
  2. Ladle the hot jam into hot jars, leaving the headspace the recipe gives. Remove air bubbles.
  3. Wipe the rims clean, place the lids, and tighten the bands fingertip-tight.
  4. Lower the filled jars into a boiling water canner with the water covering the lids. Process for the tested time, adjusting for altitude.
  5. Lift the jars out and let them cool undisturbed for 12 to 24 hours.
  6. Check the seals, and store sealed jars in a cool, dark place.

Why you should not change a tested recipe

Changing the sugar or fruit amounts in a canning recipe changes both the set and the safety margin. A blog recipe with a different ratio may look right in the pot and still be unsafe to store on the shelf. Do not adjust the sugar, fruit, or processing time of a tested recipe.

If you do not want to can

You can make a no-pectin raspberry jam for the fridge or freezer. It is not a canning recipe, so it does not need a canner. Keep it cold, and use it within the time the recipe allows. For that method and a chia option, see the low-sugar raspberry jam guide.

Storage and safety

  • Sealed jars: Store them in a cool, dark place. Refrigerate them after opening.
  • Jars that did not seal: Refrigerate them and use them first. Do not store an unsealed jar on the shelf.
  • Mold: If mold appears, discard the jar.

For the wider picture of low-sugar jam, see the low-sugar jam guide. For how long a sealed jar keeps, see how long will jam last in a sealed jar?.

The complete guide to low-sugar jam

Low-Sugar and No-Sugar Jam: A Complete Guide (With Sure-Jell)
Read the guide

Keep exploring

Guides from other topics

All topics →