Jam Making Basics

How Long to Water Bath Can Jam (Processing Times by Jar Size and Altitude)

Processing time depends on jar size, your recipe, and altitude. See example times from one pectin maker, how to adjust for elevation, and checking seals.

On this page
  1. The short answer
  2. Why processing time matters
  3. Example times from one pectin maker
  4. Adjusting for altitude
  5. Start timing at a full rolling boil
  6. After processing
  7. Common mistakes
  8. Where to go next

The short answer

Processing time comes from your tested recipe, adjusted for jar size and altitude. As an example, one pectin maker’s guidance is 5 minutes for 4-ounce jars and 10 minutes for 8- to 16-ounce jars at sea level, plus 1 minute for each 1,000 feet of elevation. Use the time from the recipe you are making, and check the altitude guidance in its source.

Why processing time matters

In a boiling water canner, the filled jars are heated long enough to reduce the spoilage microbes that can be in the jam, and the jar cools into a seal. Cutting the time short, or skipping the boil, leaves the jar less protected. Processing time is part of the tested method, not an optional step.

Example times from one pectin maker

Pomona’s Pectin publishes these water bath times for its jam and jelly directions:

Jar size Time at sea level Altitude adjustment
4 ounces 5 minutes Add 1 minute per 1,000 feet
8 to 16 ounces 10 minutes Add 1 minute per 1,000 feet

These figures are one source’s guidance, not a universal rule. Other tested recipes can list different times, and other canning guides can use different altitude adjustments. Always check the time in the recipe you are using.

Adjusting for altitude

Find your elevation before you start. Most mapping tools and local websites give it for your town. Then add time as your recipe directs. Using Pomona’s Pectin’s altitude rule for 8- to 16-ounce jars, a batch at 1,000 to 2,000 feet would be processed for 11 minutes, and a batch at 2,000 to 3,000 feet for 12 minutes.

Start timing at a full rolling boil

  1. Place the jars on the rack in the canner, with the water 1 to 2 inches above the tops of the jars.
  2. Put the lid on the canner and bring the water to a boil.
  3. Adding jars can make the water stop boiling. Put the lid back on, and bring the water back to a full rolling boil as quickly as you can.
  4. Start the timer only once the water is at a full rolling boil.

After processing

  • Lift the jars out with a jar lifter, and set them upright on a towel, not touching each other.
  • Leave them undisturbed for 12 to 24 hours.
  • Remove the bands, and check the seals. The lid center should be pulled down and should not flex.
  • Store sealed jars without the bands, in a cool, dark place.
  • If a jar did not seal, see how to fix runny jam and reprocess jelly that didn’t set for your options.

Common mistakes

  • Starting the timer too early. The timer starts at a full rolling boil, not when the jars go in.
  • Using the wrong time for the jar size. Recipes often give different times for 4-ounce and larger jars.
  • Ignoring altitude. Time changes as you go up in elevation, so check it for your location.
  • Tightening lids too hard. Air needs to escape during processing. Fingertip tight is enough.
  • Using a recipe with no processing time. Without a time, there is no tested shelf-stable method.

Where to go next

The complete guide to jam making basics

Making Jams and Jellies at Home: A Beginner's Guide
Read the guide

Keep exploring

Guides from other topics

All topics →