Short answer
Give the jam or jelly time before you decide it has failed. Many batches firm up over one to several days. If it is still runny, the usual fix is to remake it with fresh pectin, lemon juice, and sugar using a tested remaking method, then process it again. Simply boiling the whole batch longer usually does not fix a set.
Wait before you decide
Jam keeps firming as it cools. Some sources say it can take up to a week to reach its final set. Jelly can also be slow. Grape jelly is a common example. Wait at least 24 hours after jarring before you decide the batch has failed, and check it again after that.
Why jam and jelly don’t set
- Not enough pectin. Strawberries, peaches, and pears are low in natural pectin, so their recipes usually add commercial pectin. A recipe that leaves it out may not set.
- Wrong pectin, or the wrong amount. Powdered and liquid pectin are not interchangeable. Low-sugar pectin follows its own directions.
- Not cooked to the set point. If the mixture did not reach the set point, too much water is left in it. A thermometer or the cold-plate test helps you check. How to tell when jam is done cooking explains both.
- Wrong acid or sugar. Acid helps the pectin gel, and sugar binds water and helps the gel form. Changing either amount can stop the set.
- A batch that was too big. Large batches take longer to reach the set point, and the fruit can overcook while you wait. Cook smaller batches in a wide pot.
Check it before you reprocess
Put a few small plates in the freezer. Spoon a little hot jam onto a cold plate and wait one to two minutes. Push the edge with your finger. If the surface wrinkles and holds a path, it is set. If it runs back together, it is not.
How to remake unset jam or jelly
Tested remaking methods work with small batches. Remake one batch at a time. The National Center for Home Food Preservation publishes tested remaking methods for soft jellies. The amounts in those methods are set per quart, so use the exact figures from the method you choose rather than guessing.
The general steps are:
- Measure the unset product, and choose the remaking method that matches your pectin type.
- Follow that method’s instructions for adding pectin, lemon juice, and sugar, and bring the mixture to a full rolling boil for the time it gives.
- Skim the foam, then ladle the hot jam or jelly into clean, hot jars with 1/4 inch of headspace.
- Add new lids, and process in a boiling water canner for the time the method gives, adjusted for altitude. How long to water bath can jam explains how altitude changes the time.
- Cool the jars undisturbed, then check the seals.
Can you reboil an unset jam?
Boiling the whole batch longer usually does not fix a set. It can darken the fruit, dull the flavor, and make the jam harder to work with, and it does not add pectin or acid. The tested remaking method is the reliable route, because it adds what the batch is missing.
Jars that didn’t seal
If a jar’s lid flexes or pops off after cooling, the jar has not sealed. You have two options. You can refrigerate it and use it within about three weeks, or you can reprocess it promptly with a new lid. Check the current guidance from the National Center for Home Food Preservation for the time limit before you choose. Do not just tighten the old lid and put the jar on the shelf.
Why citric acid is added to jam
Acid lowers the pH of the mixture so the pectin molecules can link together into a gel. A jam that sets well is fairly acidic. Low-acid fruit often needs lemon juice in the recipe. Use bottled lemon juice when a recipe calls for it, because the acidity of fresh lemons varies.
How to tell if jam is thick enough
A jam that is ready looks glossy and spreads without running off toast. It holds a soft shape, and the fruit stays suspended. If the jam runs off a spoon in a thin stream, keep it cooking or wait for it to cool and test again. The doneness guide covers the spoon and cold-plate tests in more detail.
Thicker jam for cookies
A well-set jam holds its shape better in the oven. Do not add flour or cornstarch to a jam you plan to can. Thickeners are not part of tested canning recipes, so adding them takes the batch outside what was tested. For a batch you plan to refrigerate or freeze, cooking it to the set point is the right way to get a thicker jam.
How long jam takes to set
Plan on a day, and sometimes longer. Jam continues to firm as it cools. Check it after 24 hours, and give it more time if it is still soft.