Jam Without Pectin

How to make jam step by step?

Make jam step by step without pectin: prep the fruit, dissolve the sugar, cook to the set point or cold plate test, then jar and store it safely.

On this page
  1. What you need
  2. Step 1: Prepare the fruit and jars
  3. Step 2: Macerate (optional)
  4. Step 3: Dissolve the sugar and bring to a boil
  5. Step 4: Cook to the set point
  6. Step 5: Test for set
  7. Step 6: Jar, cool and store
  8. Common problems
  9. Where to go next

To make jam without pectin, cook chopped fruit with sugar and lemon juice until the mixture reaches its set point. At sea level that is about 220°F (104°C), or the jam passes a cold plate test. Each step below explains how to get there and how to keep the jam safe to store.

What you need

  • Fruit: About 2 pounds (900 g) of ripe but firm fruit, hulled, pitted, peeled or chopped as the recipe requires.
  • Sugar: Use the amount your recipe gives. Less sugar makes a looser jam that keeps for a shorter time.
  • Lemon juice: Use bottled lemon juice in the amount your recipe gives. Bottled juice has consistent acidity.
  • Equipment: A wide, heavy-bottomed pot, a wooden spoon, a potato masher, a ladle, a funnel, clean jars with lids, a jar lifter and two or three small plates. A jam thermometer is helpful but not required.

Step 1: Prepare the fruit and jars

Choose fruit that is ripe but still firm. Fruit that is very ripe has less natural pectin, and jam made from it often sets softly.

Wash the fruit, remove any stems, pits or peels, and chop or crush it to the texture you like. Wash the jars and lids in hot, soapy water. If you plan to store the jam on the shelf, follow a tested canning recipe for sterilizing jars and processing. Put the cold plates in the freezer now so they are ready for testing.

Step 2: Macerate (optional)

Toss the fruit with the sugar and lemon juice in a bowl or the pot. Cover and let it sit for 30 minutes, or overnight in the refrigerator. This draws juice out of the fruit and starts dissolving the sugar, which makes the boil more even.

Step 3: Dissolve the sugar and bring to a boil

Heat the mixture gently, stirring, until the sugar grains have fully dissolved. Undissolved sugar can crystallize later. Once the sugar has dissolved, raise the heat to a full boil and stir. Skim off any foam that forms on the surface.

Step 4: Cook to the set point

Lower the heat slightly so the jam boils steadily without spattering, and stir often to prevent scorching. Mash the fruit as it softens if you want a jam with a more uniform texture.

Cook until the jam reaches the set point. Pectin-free jam sets when it is about 8°F (4°C) above the boiling point of water where you are. That is 220°F (104°C) at sea level, and the target is lower at higher altitude. Water boils at a lower temperature there, so check your local boiling point before you rely on a fixed number.

Cooking time varies with the fruit, the pot and how much water the fruit gives off. Low-pectin fruit can take well over 20 minutes. Use the test, not the clock.

Step 5: Test for set

Use the cold plate test whether or not you have a thermometer:

  1. Take the pot off the heat for a moment.
  2. Spoon a little jam onto a cold plate and wait about a minute.
  3. Push the surface with your finger. If it wrinkles and does not flow back together, the jam is set.
  4. If it runs, return the pot to a simmer and test again in a few minutes.

Jam thickens as it cools, so a hot spoonful that looks a little loose may be right. The cold plate shows how it will look once it has cooled.

Step 6: Jar, cool and store

Ladle the hot jam into clean jars, leaving about 1/4 inch (6 mm) of headspace. Wipe the rims clean, add the lids and let the jars cool to room temperature.

Jam made without canning should be refrigerated and used within a few weeks. For longer storage, freeze it in freezer-safe containers and leave about 1/2 inch (1 cm) of room for expansion. Reduced-sugar jam should always be refrigerated or frozen.

For jam you want to keep on the shelf, use a tested canning recipe from a source such as the National Center for Home Food Preservation. Do not change the sugar or acid in a tested recipe unless the recipe says the change is tested.

Common problems

  • The jam will not set. The usual causes are too little acid, too little sugar or not enough cooking time. Cook longer, add a little lemon juice, or add a high-pectin fruit such as apple next time. See low-pectin fruit jam for more on this.
  • The jam is stiff or rubbery. It was cooked too long. Test earlier next time, and remember that the jam firms as it cools.
  • Sugar crystals. The sugar usually did not fully dissolve before the boil. Stir gently until the grains are gone before raising the heat.
  • The bottom scorched. Lower the heat and stir more often. Scorched jam has a bitter taste and cannot be fixed.

Where to go next

Once you have the method, try a fruit-specific recipe. Strawberry jam without pectin is a good first choice. For apples, the apple cores and peels method shows how to add natural pectin. For a small batch, see how to make a little bit of strawberry jam. For the wider picture, see homemade jam without pectin.

The complete guide to jam without pectin

How to Make Homemade Jam Without Pectin
Read the guide

Keep exploring

Guides from other topics

All topics →